TEFAL EXPRESS ANTI-CALC Mode D'emploi page 24

1800116691 EXPRESS-ANTICALC:TEFAL
White streaks come through the holes in
the soleplate.
Brown streaks come through the holes in
the soleplate and stain the linen.
The soleplate is dirty or brown and may
stain the linen.
There is no steam or there is little steam. The water tank is empty (red light on).
Steam comes out around the collector.
The red "water tank empty" light is on.
Steam or water escapes under the
appliance.
The "anti calc" indicator is lit.
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
If you have any problems or queries please call our Customer Relations team first for expert help and advice:
Your generator tank is ejecting scale as it
has not been descaled regularly.
You are using chemical descaling agents
or additives in the water for ironing.
Fabric fibres have accumulated in the
holes of the soleplate and are burning.
Your linen is not rinsed sufficiently or you
have ironed a new garment before
washing it.
You are ironing at too high a temperature. See our recommendations regarding
You are using starch.
The steam output control dial is set at
minimum.
The soleplate temperature is set to the
maximum.
The collector is not tightened correctly.
The collector seal is damaged.
The appliance is faulty.
The water tank is empty.
The rinse plug seal is damaged.
You have not pressed the "Restart" button. Press the "Restart" button on the control
0845 602 1454 - UK
(01) 677 4003 - Ireland
or consult our website - www.tefal.co.uk
16/06/09 15:40
Rinse the collector (see § descaling your
steam generator).
Never add this type of product in the
water tank or in the boiler (see page 5 for
what water may be used). Contact an
Approved Service Centre.
Clean the soleplate with a non-metallic
sponge.
Ensure linen is rinsed thoroughly to remove
any soap deposits or chemicals on new
garmentswhichmaybesuckedupbytheiron.
temperature control setting.
Always spray starch on the reverse side of
the fabric to be ironed.
Fill the water tank.
Increase the steam output (control dial on
the control panel).
The steam generator operates normally
but the steam is very hot and dry, and hard
to see.
Tighten the collector.
Contact an Approved Service Centre.
Do not use the steam generator and
contact an Approved Service Centre.
Fill the water tank.
Do not use the steam generator and
contact an Approved Service Centre.
panel.
Page 23