BH FITNESS H8705 Instructions De Montage Et Utilisation page 11

Mod. H871.-
Connect the two terminals (O and P)
figure 6, coming out of the handlebar
stem (B) and the main body (A).
Insert the handlebar stem (B) onto the
boss on the main body (A) taking care
not to pinch the cables.
Fit the bolts (a) and flat washers, as
shown in figure 6, align the handlebar
stem and hand tighten.
Mod. H872N
Connect the two terminals (O and P)
figure 7, coming out of the handlebar
stem (B) and the main body (A).
Connect the two terminals (y) and (z),
coming out of the handlebar stem (B)
and the main body (A), as shown in
figure 7.
Insert the handlebar stem (B) onto the
boss on the main body (A) taking care
not to pinch the cables.
Fit the bolts (a) and flat washers, as
shown in figure 7, align the handlebar
stem and hand tighten.
5. FITTING
HOLDER
Take the bottle holder (F), insert it in
through the top of the handlebar (B),
Fig. 8.
Next, release the screws (n) on the
handlebar (B), position the bottle
holder and secure it by using the
screws (n) removed previously.
6. INSTRUCTIONS
FITTING THE SADDLE
In order to raise or lower the saddle
post (J),figure 9, fi rst loosen off the
control knob (LL) on the saddle post a
little by turning it in an anticlockwise
direction.
THE BOTTLE
FOR
Pull the control knob back and without
releasing it, move the saddle post up
or down. Next, take the horizontal tube
for the saddle (F) and attach the
saddle (I) to it, figure 9, tighten the
nuts (Z).
VERTICAL ADJUSTMENT.
In order to raise or lower the saddle
post, fi rst loosen off the control knob
(LL) on the saddle post a little by
turning it in an anticlockwise direction,
pull the control knob back and without
releasing it, move the saddle post up
or down, figure 9. When it is at the
right height release the knob and it will
lock into a hole on the saddle post.
Tighten it up by turning the control
knob (LL) in a clockwise direction.
HORIZONTAL ADJUSTMENT.
To adjust the saddle's horizontal
position, loosen the control knob (T)
on the saddle's horizontal bar and
move the saddle, along with the bar,
into the desired position, then tighten
the control knob securely, figure 9.
TILTING THE SADDLE.
The saddle can be tilted backward or
forward. Loosen off nut (Z) shown in
figure 9, located under the saddle, tilt
the saddle into the desired position
and then retighten the nut securely.
Do not adjust the tilt of the saddle
while you are still sitting on it.
7. FITTING THE MONITOR
Mod. H 8705.-
Bring the monitor (E) to the handlebar
stem (B) figure 10, connect the two
terminals (P / Q) coming out of the
11