BH FITNESS H8705 Instructions De Montage Et Utilisation page 10

1. ASSEMBLY INSTRUCTIONS
The assistance of a second person
is advisable for the assembly work.
Take the unit out of its box and make
sure that all of the pieces are there:
(A) Main body; (B) handlebar stem;
(C) Stabiliser bar with wheels; (D)
Stabiliser bar with adjustable blocks;
(E) Monitor with handlebar; (G) and
(H) Saddle post covers; (I) Saddle; (L)
Left pedal; (R) Right pedal; (LL)
Saddle height adjustment knob; (g)
Mains transformer; Bag of screws
containing: (c) Self tapping screw
ST4.0x14; (d) Flatwashers M4x16; (e)
Double ended
spanner with screwdriver; Allen key 6
mm.
2. FITTING THE STABILISER
BARS
Rest the main body on a wad of
packaging, as shown in figure 2 (this
will help with the assembly work).
Take hold of the front stabiliser bar
fitted with wheels (C).
Remove the bolts (b) and their nuts
and washers. Now line up the two red
dots, as shown in figure 2, and refit
the bolts (b), nuts and washers.
Tighten securely.
Next, take the finish trim piece for
stabiliser (G) and rest it on the
stabiliser bar with wheels (C) that you
have just assembled. Attach the trim
to the bottom
threaded screws (c) and flat washers
(d).
Next, rest the main body on a wad of
packaging material
assembly easier).
stabiliser with adjustable feet (D) and
position it on the machine's rear stand,
spanner; (f)
using the plastic
(this makes
Take the
insert the bolts (b) with the flat
washers and nuts, tighten securely.
Then take the finish trim piece for
stabiliser (G) and rest it on the
stabiliser bar with wheels (C) that you
have just assembled. Attach the trim
to the
threaded screws (c) and flat washers
(d), figure 3.
3. ATTACHING THE PEDALS
The assembly instructions for the
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on the pedal or the
crank. Right and left refer to the
Box position that the user adopts when
sitting on the saddle to do the
exercises.
The right-hand pedal, marked with the
letter (R), screws onto the right-hand
crank (Q), also marked with an (R), in
a clockwise
securely, figure 4.
The left-hand pedal, marked with the
letter (L), screws onto the left-hand
crank, also marked with an (L), in an
anti-clockwise
securely figure 4.
4. FITTING THE HANDLEBAR
STEM
Mod. H8705.-
Connect the two terminals (O and P)
figure 5, coming out of the handlebar
stem (B) and the main body (A).
Insert the handlebar stem (B) onto the
boss on the main body (A) taking care
not to pinch the cables.
Fit the bolts (a) and flat washers, as
shown in figure 5, align the handlebar
rear stem and hand tighten.
10
bottom using
direction.
direction.
the plastic
Tighten
Tighten