Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11.6
Groove milling cutter set
The groove milling cutter set is designed to mill nuts depending on the task by using the edge
guide
(Fig.
6/26) or the stop angle
11.6.1
Cutting tool
The installation of BEPo HW groove milling cutter equals to the installation and changing of the
cutting tool
(Chap.
6).
11.6.2
Edge guide
For more information on how to mill nuts with BEPo UFS 115 N Twist by using the edge guide
refer to
(Chap. 11.1)
up to
11.6.3
Stop angle
How to mill nuts with BEPo UFS 115 N Twist by using the stop angle:
o
Plug off the machine before starting to work on it.
o
Remove adjustable cover, see
o
Fit the edge guide, see
o
Slide the stop angle
22) and fix it by turning the sliding spindle
o
Using the clamp screw
45° to 90°.
(Fig.
5/18).
(Chap.
11.3).
(Chap.
11.4).
(Chap.
11.1).
(Fig.
3/18) from the top over the sliding plate for edge guide
(Fig.
3/19) you can set the stop angle from
(Fig.
3/16) clockwise.
(Fig. 3/
35
Publicité
Chapitres
Table des Matières
