Fitting The Accessories; Fitting The Sliding Plate Of The Edge Guide; Guiding The Machine On The Edge Guide; Fixing The Edge Guide - Janser 228 856 000 Instructions De Service

11

Fitting the accessories

11.1

Fitting the sliding plate of the edge guide

o Remove the sliding plate/chip guard
sliding plate of the edge guide
screwed together are clean.
11.2

Guiding the machine on the edge guide

o
The guide groove
guide (Fig. 6/26).
11.3

Fixing the edge guide

Depending on the tasks and local conditions, the edge guide can be fixed by
– screw clamps (Fig.
– suction pads (Fig.
Use the connecting linkage
both sides of the edge guide and fix them by the clamp screws
pads with the lever righted and throw the lever for fixing.
(Fig.
(Fig. 5/24). Make sure that all areas that are to be
(Fig. 5/25) in the sliding plate provides a precise guideline on the edge
6/27) or
6/30) on smooth and gastight surfaces.
(Fig. 6/31) to insert the suction pads into the T-groove
2/13) by loosening the 2 screws. Screw on the
(Fig. 6/29). Press on the suction
(Fig. 6/28) at
33