Accessories; Flocked Cover; Portable Sanding Block With Hook And Lope Tape Support - Janser 228 856 000 Instructions De Service

10

Accessories

The following original accessories are required for using the machine and are available in
specialist shops:
Designation
Cutting tool
BEPo - diamond cutting disk tiles / plaster
Cutting tool
BEPo - HW cutting wheel solid wood
Cutting tool
BEPo - HW cutting wheel laminate / MDF / chip board
Cutting tool
BEPo - HW groove milling cutter 4mm
Cutting tool
BEPo - groove milling cutter set
Flocked cover - for a ground protecting working method
Sanding block - e.g., for chamfering an installed door leaf
Sliding plate for edge guide
Edge guide 1,400mm
Edge guide 700mm
Screw clamps for edge guide (2 pieces)
Suction pads for edge guide (2 pieces)
Wooden case for machine and tools
10.1

Flocked cover

In special cases, when a ground protective working method is absolutely necessary (e.g.
hardwood floors), you can replace the lower cover
specifically flocked cover. The specifically treated surface avoids damaging the ground while
working.
10.2

Portable sanding block with hook and lope tape support

For special purposes like shortening doors, you can use the specifically shaped sanding block to
bevel the cutting edges without having to remove the component.
32
(Fig. 4/22) which is installed by default with a
Order No.
1115/053
1115/055
1115/056
1115/057
1115/125
1115/058
1115/070
1115/114
1115/060
1115/061
1115/068
1115/163
1115/115