Flotec FP0S1800A Notice D'utilisation page 4

Operation
Operation
Risk of electric shock. Can shock, burn
or kill. Do not handle a pump or pump motor with wet
hands or when standing on wet or damp surface, or in
water.
1. Shaft seal depends on water for lubrication. Do not
operate pump unless it is submerged in water as seal
may be damaged if allowed to r
un dry.
2. Motor is equipped with automatic reset thermal
protector. If temperature in motor should rise unduly,
switch will cut off all power before damage can be
done to motor. When motor has cooled sufficiently,
switch will reset automatically and restart motor. If
protector trips repeatedly, pump should be removed
and checked as to cause of difficulty. Low voltage,
long extension cords, clogged impeller, very low head
or lift, or a plugged or frozen discharge pipe, etc.,
could cause cycling.
Bracket
Pin
Float
NOTICE For Model FPOS1800LTS, see instructions included with replacement switch, Part Number FPS17-66.
For parts or assistance, call Flotec Customer Service at
Vertical Switch Assembly
Switch
Housing
Bracket
Mounting
Screws
Rod Stop
Rod
3. Pump will not remove all water. If operating a pump
manually, and suddenly no water comes out of the
discharge hose, shut off the unit immediately. The
water level is probably very low and the unit has
broken prime.
Risk of electric shock. Can shock, burn
or kill. Before attempting to check why unit has stopped
operating, disconnect power from unit.
1
Mount the bracket onto the switch
housing.
Slip the float and then the rod stop
2
onto the rod past the second nib.
3 Insert the rod assembly up into the
switch housing and lock into place
with the pin.
NOTICE Be sure the pin holds the
rod into the switch housing or the
pump will not shut off.
4 Attach the switch to the pump as shown.
Tethered Float Switch
Do Not Change the
preset tether length.
3-1/2"
(89 mm)
1-800-365-6832
4