MCS Master BCM 191AB Manuel D'utilisation Et De Maintenance page 20

PLACE THEM ON THE SIDES OF THE
en
APPLIANCE (Pic. 2).
it
de
►►3.1. HANDLING
es
Handle the cooler with the utmost care,
moving it horizontally.
fr
nl
►►3.2. PRE-INSTALLATION AND IN-
pt
STALLATION METHOD
da (Pic. 3)
During installation, the electrical connec-
fi
tion, water connection, use and mainte-
nance of the cooler, comply with all local
no
regulations and standards in force.
sv
►3.2.1. The cooler must be installed on a
stable and level structure, so as to pre-
pl
vent any risk (the structure and the plugs
ru
must be adequate to support the weight
of the appliance).
cs
►3.2.2. Install the cooler in well ventilated
hu
areas.
►3.2.3. The cooler can only be installed
sl
outside (on the roof or on the wall).
tr
►3.2.4. Install the cooler away from fire-
places, heat sources and possible
hr
sparks, in order to prevent serious dam-
lt
age.
►3.2.5. Do not drill screws or tie rods into
lv
the cooler during installation.
et
►3.2.6. The minimum installation distance
between the cooler and walls or other
ro
objects is 0.5 m (ensure suitable spaces
sk
for maintenance around the cooler).
bg
uk
►►3.3. DUCTING METHOD
By connecting a conduit to the cooler, the
bs
outgoing air can be carried to where cool-
el ing is required.
It is crucial for the entire ducting conduit to
zh
be designed and structured correctly.
►3.3.1. Use conduits of suitable section
(the average air speed inside the conduit
is 3-6 m/s).
►3.3.2. The ducting should be as short as
possible.
►3.3.3. Do not install the duct with elbow
bends.
►3.3.4. Do not branch the air flow into sev-
eral conduits.
NOTE: WE RECOMMEND USING CON-
DUITS MADE OF GALVANISED SHEET
METAL, PLASTIC OR FIBREGLASS.
►►3.4. CONNECTION TO THE ELEC-
TRICITY MAINS AND CONNECTION OF
THE PROBE
IMPORTANT: THE POWER SUPPLY
AND CONNECTION LINE MUST BE IN-
STALLED BY A QUALIFIED TECHNICIAN
USING SUITABLE DEVICES AND IN-
STRUMENTS, IN ACCORDANCE WITH
NATIONAL REGULATIONS AND THE
STANDARDS IN FORCE.
►3.4.1. By removing the screws on the
side of the cooler you have access to the
interior of the appliance (Pic. 2).
►3.4.2. Feed the cables (power cable, se-
rial connection cable, probe cable and
solenoid valve cable) through the hole
near the electrical panel on the bottom of
the cooler (Pic. 4).
►3.4.3. Only connect and power the cool-
er with the voltage and frequency speci-
fied on the nameplate and with cables of
suitable section.
►3.4.4. Correct operation requires the
cooler to be earthed properly.
►3.4.5. Connect the display to the serial
cable (Pic. 5).
►3.4.6. Connect the temperature / humid-
ity probe cable (based on the model) to
the electronic panel (Pic. 5).
►3.4.7. Connect the solenoid valve cable
to the electrical panel (Pic. 5).
NOTE: MAKE SURE THE POLARITIES
ARE FOLLOWED WHEN CONNECTING
TO THE MAINS. WE RECOMMEND US-
ING A SUITABLE RESIDUAL CURRENT
DEVICE (SEE NAMEPLATE).