Breguet CLASSIQUE COMPLICATIONS 1801 Mode D'emploi page 5

1801/1808
"C "
WATCH
LASSIQUE
The crown has two positions:
1. Neutral position
(manual winding)
2. Time-setting position
, ,
TOURBILLON MANUALLY WOUND
Starting the watch
Crown in position 1. This position
allows you to wind the movement. To
start the watch, wind it fully by turn-
ing the crown upwards (
resistance is felt. ON NO ACCOUNT
FORCE THE CROWN. When the resis-
tance is felt at the end of winding, it is
important to turn the crown down-
wards ( ) (at least
M M
to release the crown wheel.Thereafter,
wind the watch daily, preferably at a
regular time.
,
WATER
Setting the time
Pull the crown out to position 2. Then
turn the crown upwards (
the hands forwards to the desired
) until time. For accurate time-setting, ensure
L L
that the last operation was done in a
clockwise direction. Then push the
crown back to position 1. After this
operation, rotate the crown down-
1 / turn) in order wards (
4
freely.
- 30
RESISTANT TO
) to move
L L
) to make sure it turns
M M
M