OERTLI AD252 Notice De Montage page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
3
Pairing a remote control
The pairing must be done in the boiler room on first
initialisation.
Each radio remote control is given a unique identifying number in the
factory, which enables the radio module to recognise it. This
identifying number is transmitted to the radio module by the pairing
sequence described below.
This operation is memorised, even after the batteries are
changed.
1
Press the button on the radio module using the tip of a ballpoint
pen. The light on the radio module comes on.
The radio module exits the pairing programme after 2 minutes.
Press simultaneously for 5 sec. on keys
remote control.
The text cir A is displayed.
%
0
2
4
6
8
10
12
$
MODE
C002353-C
Turn the settings button to select the desired circuit.
Press the settings button to confirm the selection.
24/06/2011 - 300020522-001-F
3
2
and
14
16
18
20
22
24
4
5
After a few seconds, the light on the radio module goes off
and the remote control displays the message "init" while it
sychronises itself with the module.
After a few seconds, the message is cleared and the current display
appears.
Pairing failed
C002352-C
on the
If there is a problem, the warning light goes out after 2 minutes
and the remote control displays the message Pb rF.
If the message Pb rF appears, the radio module is not paired with
the radio remote control. Repeat the pairing sequence.
AD252
7
6
C002354-E
2
1
C002355-E
9

Publicité

Table des Matières
loading

Table des Matières