Using The Vacuum Cleaner - ECG VM 3100 HOBBY Mode D'emploi

4. Close both the locks and snap them firmly to the tabs on the body of the vacuum cleaner (
5. Insert the end of the hose in the opening in the body of the vacuum cleaner and secure it by turning
clockwise (
5
1

USING THE VACUUM CLEANER

Selection of suitable accessories according to the type of the vacuumed surface
Accessories suitable for various types of floors and surfaces that are supplied with the vacuum cleaner:
GB
• Combined floor nozzle with a switch for hard floors or carpets, hinged mechanism makes cleaning
A
corners and hard to reach places easy.
• Combined tapered nozzle and dust brush for sofas, curtains and hard to reach places in corners or
B
between furniture.
• Upholstery nozzle is suitable for vacuuming the furniture and other delicate surfaces.
C
A
Vacuuming
• Make sure that the vacuum cleaner is assembled according to the instructions.
• Attach hose to the vacuum cleaner and insert the required accessory to the telescopic tube.
• Plug the power cord into an electrical outlet, turn on the vacuum cleaner power switch and Vacuum as
needed. After use, switch off the power switch and unplug the power cord from the outlet.
Wet vacuuming
• Remember to remove the dust bag before any wet vacuuming.
• When vacuuming a small amount of liquid, the HEPA filter can stay in place. If you vacuum a large volume
of liquid, we recommend that you remove the HEPA filter and install a foam filter instead.
• When the liquid in the container of the vacuum cleaner reaches the maximum permitted level, the float
rises and the locking mechanism automatically stops the flow of air through the motor. In that event,
unplug the vacuum cleaner, disconnect from power and empty the vacuum cleaner container.
• It is necessary to dry the filter after wet vacuuming to limit possible mould formation and destruction of
the filter.
Dry vacuuming
• Make sure that the HEPA filter is properly installed. Never vacuum without installed filter.
28
28
).
2A 2B 3 4
B
C
).
4
5