Playing A Usb Flash Drive; Playing An External Device; Playing Back From An External Device Connected To The Line In Jacks - Onkyo CS-265DAB Manuel D'instructions

Playing a USB Flash Drive

This manual describes the procedure for using the
remote controller, unless otherwise specified.
1 Press the [USB] button to change the input
source to "USB/iPod."
2 Insert a USB flash drive in the USB port.
USB flash drive
3 To start playback, press the [1/3]
button.
The procedure for selecting folders and files, and
using 1-Folder mode, repeat playback, and
random playback is the same as for playing back
MP3 discs (see page 20).
About the Resume function:
The Resume function is enabled during audio playback
from a connected USB flash drive.
During playback, press the [2] button once. The
"Resume" message appears and the stop position is
stored.
Press the [1/3] button again to resume playback
from the stop position.
Alternatively, to stop playback completely, press the
[2] button again.
Note:
• Do not connect your USB flash drive via a USB hub.
• When connecting or disconnecting a USB flash drive,
use your hand to support the CD receiver so that it
does not move.
• For details on the usable formats for a USB flash
drive, refer to page 12 "Playback from USB Flash
Drives".
• Do not connect the CD receiver's USB port to a USB
port on your computer.
30
En-

Playing an External Device

Playing Back from an External
Device Connected to the LINE IN
Jacks
1 Press the [LINE] button to change the
input source to "LINE."
2 Play back the external device.
If the volume level is substantially different than
the that of other audio sources, adjust the LINE
input level.
Adjusting the LINE input level
The volume level of the earphone output on some
mobile music players may be substantially lower than
that of other audio sources. Therefore, if you switch the
input source from such a player (connected to the LINE
IN jacks) to another input source, you may notice the
level variance. In such a case, follow the steps below to
adjust the LINE input level.
1. Press the [LINE] button to change the input
source to "LINE."
2. Press the [MENU] button to display "Input
Level >", then press the [ENTER] button.
3. Play back music, while adjusting the volume
level using the [q]/[w] buttons.
You can ajust the input level in a range from –6
to +12.
Press the [ENTER] button to return to the
previous display.
Note:
• This adjustment affects only the speaker volume; the
headphone volume cannot be adjusted.
• If the volume level of your mobile music player is
substantially low, this adjustment may not be
sufficient. In such a case, raise the volume level on the
mobile music player.
• If the input level is raised excessively, the sound may
distort. If this occurs, adjust the input level
appropriately.