Makita 6924N Manuel D'instruction page 5

► 1. Tip rod 2. Tip rod spring 3. Inner sleeve spring
Installing the outer and inner
sleeves
Hold the inner sleeve with the pin facing upward. Place
the outer sleeve over the inner sleeve. Press the pin to
allow inserting the inner sleeve, then release the pin to
secure the inner sleeve.
► 1. Outer sleeve 2. Pin 3. Inner sleeve
Insert the outer and inner sleeves into the tool while
rotating the inner sleeve alternately clockwise and
counterclockwise until there is no gap between the
outer sleeve and the tool. See the figure. Then tighten
the two screws securely.
3
4
► 1. There should be no gap between the outer
sleeve and the tool. 2. Inner sleeve 3. Outer sleeve
4. Screw
1
2
3
1
2
3
2
1
OPERATION
Bolt installation
Slip the tool onto the bolt so that the inner sleeve com-
pletely covers the bolt tip.
► 1. Inner sleeve 2. Bolt tip
CAUTION:
• Be careful when fitting the sleeve onto the bolt
tip. Striking the tip can damage it so that it will
no longer fit inside the sleeve properly.
Keep forward pressure on the tool while sliding it further
forward until the outer sleeve fits completely over the
nut. If the tool fails to fit completely over the nut, twist
the tool slightly right and left while pushing forward.
► 1. Outer sleeve 2. Nut
Pull the switch trigger. The outer sleeve turns to begin
tightening the nut.
When the specified torque is attained, the bolt tip will be
sheared at its notched portion. The bolt tip will remain
inside the inner sleeve.
5 ENGLISH
1
2
1
2