Using The Machine - Clatronic DB 2919 Mode D'emploi & Garantie

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

•

Clean the ironing base with a slightly damp cloth.

•

Fill the water reservoir at the reﬁ ll opening (8), using a ﬁ lling container.

•

Preferably use distilled water or clear tap water (maximum water hardness

level 2). If water is harder, used distilled water only.

•

Do not ﬁ ll battery water, water from the clothes dryer and water containing

additives (such as starch, perfume, softener or other chemicals) into the water

reservoir. This could damage the iron due to residues forming in the steam

chamber. These residues may cause impurities to the fabric when dropping out

of the holes in the soleplate.

NOTE: Only clothes should to be ironed with this machine.

•

Remove any protective ﬁ lms and adhesive labels from the stainless steel

soleplate before using the appliance.

•

Completely unwind the line cord.

Ironing without steam

1. Place the iron on its stand.

2. Set the steam control (4) to the lowest level (see „Steam Ironing").

3. Always move the temperature control to the lowest temperature setting (before

„b") prior to connecting the appliance with, or disconnecting it from a power

point.

4. Sort out the garments according to their ironing temperatures. Start with the

lower temperatures. It is set with the thermostat (1):

•

Synthetics, silk

• •

Wool

• • •

Cotton, linen

MAX

5. Electrical connection

•

Make sure that the iron voltage (see name plate) and the line voltage

match.

•

Only connect the machine to a properly installed safety socket,

230 V/50 Hz.

6. The control lamp (2) lights up. As soon as it shuts off, the set temperature is

reached. Now you can start to iron.

7. Always pull the plug out of the socket after using the iron.

05-DB 2919_neu_2 39

First Use of the Machine