Cleaning the Nozzle Manually
You can clean the nozzles manually (such as by scrubbing those parts using a sponge to clean the stains etc.).
Follow the procedures below to extend the nozzles for cleaning.
1. Set the [AUTO FLUSH] and [AUTO OPEN/CLOSE] to [OFF] to disable these functions.
70)
2. Lift the seat lid and seat.
3. Follow the procedures below.
HOME
MAINTENANCE
MOVE OUT NOZZLE
REAR NOZZLE
FRONT NOZZLE
NOZZLE SHUTTER
PRESS OK TO MOVE OUT
NOZZLE
PRESS OK TO MOVE
BACK NOZZLE
4. Clean the nozzles.
5. Return the setting of the [AUTO FLUSH] and [AUTO OPEN/CLOSE].
NOTE:
• Do not apply excessive force to the nozzles, as this may cause failure.
• Do not pull or push the nozzles. The nozzle will not be retracted and failure may occur.
If you pull or push the nozzles by mistake, turn off the power of the toilet by pressing the power button on the
toilet, then turn on the power after 10 seconds.
Press "OK"
Press "OK"
Press "OK"
Select with the command (↑↓), and then press "OK".
Press "OK"
Press "OK"
99
(Page
71)
(Page
71)
(Page
70)
Cleaning
(Page