LGB 20761 Instructions De Service page 7

GB
USA
20761
DR-Steam Loco, 99 5001
The Prototype
The small German town of
Spremberg operated a narrow
gauge line that ran from the rail-
way station into the town. Over
the years, this line evolved into a
23 km (14 mi.) industrial railway
network. The railway used twin-
axle locomotives, including this
little loco with its big round boiler.
Built in 1925 by Borsig, this
powerful machine remained in
service on the Spremberg net-
work until the railway closed in
1956. Later, the loco was over-
hauled and used on the Deutsche
Reichsbahn (DR) Harzquer line.
THE MODEL
This detailed replica features:
- weather-resistant construction
- three-way power control switch
- protected gearbox with seven-
pole Bühler motor
- four powered wheels
- one traction tires
- six power pickups
- voltage stabilization circuit
- smoke generator
- automatic directional lantern
- one multi-purpose socket
- length: 240 mm (9.4 in.)
- weight: 1300 grams (2.9 lb.)
THE PROGRAM
With this model, we recommend
the following items:
- 31610 DR Passenger Car,
900-229
- 40120 Low-Side Gondola,
Cabin, Gray
- 40220 DR Bed Frame Car
- 41352 Steam Sound Car, 2 axle
For information on the complete
LGB program, see the LGB cata-
log.
OPERATION
Operating Modes
This model has a three-way
power control switch mounted in
the cab (Fig. 1):
Position 0: All power off
Position 1: Power to lights and
smoke generator
Position 2: Power to lights, smoke
generator and motor
(factory pre-set)
Multi-Train System
This model has a "D" gearbox and
decoder interface. It can be equip-
ped with an LGB Multi-Train
System Decoder (55020) using a
Decoder Interface Cable (55026).
We strongly recommend decoder
installation by an LGB service
station. For more information,
contact your authorized LGB
retailer or an LGB service station
(see Service).
Hint: If this model is equipped
with a decoder, the digital/analog
DIP switches on the loco circuit
board will be set to OFF. On deco-
der-equipped models, the DIP
switches remain in this setting,
even if the models are used on an
analog layout.
Lighting
This model features directional
lighting. The model has a „flat"
multi-purpose socket, with a
removable cover, on the rear of
the cab (Fig. 5). This socket can
be used to provide track power to
cars with lighting or sound elec-
tronics.
To remove the cover of the
socket, pull it straight out. If the
cover is tight, gently use a small
straight screwdriver to pry it out.
(Do not pull out the rectangular
outer housing.)
Smoke Generator
This model is equipped with a
smoke generator. A small supply
of LGB Smoke and Cleaning
Fluid is included with this model.
For best operation, fill the genera-
tor halfway with fluid. If the gene-
rator is overfilled, it will not con-
vert the fluid into smoke.
Attention! Only use LGB Smoke
and Cleaning Fluid (50010).
Other fluids may damage your
locomotive.
Attention! Never touch the hea-
ting element in the center of the
smoke generator. It is fragile.
Power Supply
Attention! For safety and reliabi-
lity, operate this model with LGB
6