Carat T-6010 Mode D'emploi page 36

GB
ADJUSTING HEIGHT ON THE MOTOR HEAD
The cutting head has a register to adjust the cutting
height.
In case of touching of the cutting disk on the
working table or not complete cut of the material,
proceed as follows:
1) unloosen the adjustment tightening nut (A) of
the register (B) using a 13 mm spanner and
adjust the cutting head in the right position
(photo 25).
2) lock the register once again tightening the
nut (A).
2 2 5 5
ADJUSTING THE SLIDING CARRIAGE
The sliding carriage is fitted with an adjustment
scale.
When excess lateral
movement occurs, proceed as follows:
1) using a 13 mm spanner and a 6 mm allen
wrench, slacken the lower wheel supports
(photo 26)
2) move the lower wheel support in the adjustment
slot until all vertical play is removed (photo 26).
3) tighten the lower wheel support again.
2 2 6 6
and vertical carriage
WARNING !
IN CASE OF LATERAL MOVEMENT OF THE
CARRIAGE, TIGHTEN
SUPPORTS FURTHER (PHOTO 27).
2 2 7 7
12. Disposal
If all or part of the machine is to be scrapped, the
materials should be disposed of according to
current legislation.
Electric Motor
Aluminium
Steel
Copper
Polyamide
Main Casing
Steel
Polyamide
Aluminium
Submerged Pump
Polyamide
Steel
Aluminium
Copper
Epoxy Resin
The European Directive 2002/96/CE
arranges that in the event of scrapping of
electrical equipment, they must not be
36
ALL THE WHEEL
AL
AC
CU
PA
AC
PA
AL
PA
AC
AL
CU