Carat T-6010 Mode D'emploi page 28

GB
"TRANSLATION OF THE ORIGINAL INSTRUCTIONS"
Technical Data
Power supply:
Power used:
Type of operation allowed:
INTERMITTENT – SERVICE S6 40%
40%
60%
Rotation speed:
Amperometric circuit breaker:
Thermal circuit breaker:
IP level:
Working mass:
Tank capacity
(min/max)
Cutting tool
WET CUTTING DIAMOND TIPPED DISC
LASER / SECTORS:
concrete, natural stone, granite, abrasive materials
THE COMBINATIONS OF TOOL / MATERIAL TO
BE CUT ARE A ROUGH GUIDE ONLY.
ALWAYS APPLY
INSTRUCTIONS SUPPLIED BY THE TOOL
MANUFACTURER
APPLICATION.
Tool diameter:
Tool hole:
Max cutting depth:
90° cut:
90° cut in two passes:
Max cut length:
Water circulation pump:
Under working conditions, the machine has a
noise emission above 85 dB (A).
400V 50Hz~
operating under load
running freely
1400 min
10-16A
160°C
80 Kg
: 19 / 25 L
THE OPERATING
BEFORE EACH
T-5010 T-6010
Ø500 mm Ø600 mm
25.4 mm 25.4 mm
170 mm 220 mm
235 mm 285 mm
750 mm
S3 230V 50/60Hz
The level of noise emitted by the machine was
measured in accordance with UN EN12418 and
UN EN3744 standards, in conformance with
directive 98/37/EC.
LW - SOUND POWER LEVEL = 88.1/0.6 dB(A)
/mW(A)
LOP - SOUND PRESSURE LEVEL AT THE
4 Kw
OPERATING POSITION= 77.5 dB(A)
LOP Max - PEAK SOUND PRESSURE LEVEL IN
THE OPERATING POSITIO N= 85.2 dB(C
Measurements were taken with no load and at the
maximum speed using a turbo cutting tool with a
diameter of 600 mm. Art. 896C.
-1
Under working conditions, the machine has a noise
emission above 85 dB (A).
The hand-arm vibration level transmitted was
54
measured in accordance with the UN ISO 5349-1
standard during the cutting of poroton brick.
(L 275 x L 190 x H 135 mm) with a turbo cutting tool
with a diameter of 600mm. Art. 896C
- Weighted acceleration value at = 0.82 m/s2
(measurement uncertainty of 0,19m/s2).
28