Connecting The Power Pack; Vehicles With Negative Earth; Attempting To Start; Removing The Power Pack - APA 16553 Manuel De L'opérateur

6.3.1 CONNECTING THE POWER PACK

VEHICLES WITH NEGATIVE EARTH

Make sure that the Power Pack is switched off , the charge
status display must not light up. The Power Pack switches
itself off after around 10 seconds when not in use. Wait until
the Power Pack has switched off before continuing.
Switch off the ignition and all electrical consumers of the
vehicle (radio, lights, rear window heating, seat heating
etc.). Apply the parking brake.
First connect the red (+) pole callipers (Position 17 in the
overview) to the plus terminal of your vehicle battery.
The black (-) pole callipers (Position 15 in the overview) is
connected, as far as possible from the battery, to the motor
block or chassis (not to a painted part).

6.3.2 ATTEMPTING TO START

Switch on the Power Pack by pressing the ON/OFF switch.
Start the motor. Do not operate the starter for longer than
6 seconds. The battery of the Power Pack is not designed
for longer starting attempts. Pause for at least 5 minutes
between two starting attempts. If the motor does not start
after three attempts, abort the process and investigate the
cause of the defect.

6.3.3 REMOVING THE POWER PACK

First disconnect the black (-) pole calliper and attach the
pole calliper to the designated holder. Then disconnect
the red (+) pole calliper and attach the pole calliper to the
designated holder. Always maintain this sequence.
Recharge the Power Pack.

6.4 USE AS 12 V VOLTAGE SUPPLY

The Power Pack can be used as a 12 V direct current source
for many devices that can be operated with 12 V direct
current and a cigarette lighter plug. Plug the cigarette
lighter plug of the device you wish to operated into the
12 V outlets (Position 6 in the overview). The device you
wish to operate should not require a current greater than
10 A.

6.5 USE AS A USB CHARGER

Thanks to the USB port (Position 11 in the overview), the
Power Pack may also be used as a charger for mobi-
le telephones, smartphones, tablets, MP3 players and
similar devices. To recharge a USB device, fi rst connect it with
the associated charging cable (not included in the scope of
delivery). Plug the USB plug on the charging cable into the
USB port on the Power Pack. Start charging by pressing the
ON/OFF switch (Position 8 in the overview).
10

6.6 LED INDICATOR FIELD

The Power Pack has an LED indicator fi eld. This can be used
either as a work light or a warning light. Hold down the ON/
OFF switch (Position 8 in the overview) until the work light
switches on. Pressing the switch once again turns off the
warning light (fl ashing), and pressing yet again turns the
LED indicator fi eld off completely.

6.7 COMPRESSOR

In order to be able to work with the compressor, fi rst remove
the air hose from the storage compartment (Position 16 in
the overview).

6.7.1 FILLING A TYRE USING THE CAR VALVE

SCHRADER VALVE

Open the lock on the valve
connection
Figure 2
Lock the valve connection
Figure 4
To fi ll, switch the compressor on using the ON/OFF switch
(Position 12 in the overview).
The manometer (Position 13 in the overview) is used to give a
rough approximation of the air pressure. When the desired air
pressure is reached, switch the compressor off . Remove the
valve connection in reverse order (Figures 5 – 2).
When lling, always pay attention to
the correct air pressure (consult the
operating instructions of your vehicle for
information). The compressor is able to
supply of pressure of up to a maximum of
18 bar. If the pressure is too high, there is a
risk of explosion and injury.
Place the valve connection
on the valve
Figure 3
You can now fi ll the tyres
using the compressor
Figure 5