Inserting The Cable Holder; Preparation; Connecting The Battery Charger; Charging The Battery - APA 16627 Manuel De L'opérateur

6.2 INSERTING THE CABLE HOLDER

Insert the cable holder into the mounts (Position 6 in the overview) on the rear of the charger so that the openings of the verti-
cally aligned cable holders face away from each other.

6.3 PREPARATION

Clean the battery poles to remove dust and corrosion residue.
Only for open batteries: Remove the plugs of the battery cells. Check the liquid level in the cells, consult the
operating instructions of your battery for more information. Replenish only sufficient distilled water to ensure that the mini-
mum filling level is achieved. The liquid will expand during the charging process and the battery may overflow. Leave the cells
of the battery open until the end of the charging process.
In case of closed and maintenance-free batteries, please follow the instructions of the battery manufacturer to the letter.

6.4 CONNECTING THE BATTERY CHARGER

Caution: Make sure that the charger is not connected to the power socket. Always connect the red positive cable
(+) of the charger (Position 9 in the overview) to the positive pole of the battery first. Then connect the black minus
cable (-) to the minus pole of the battery. If you charge the battery in situ, connect the black negative cable (-) to the
car body (exposed part), far away from the battery, the carburettor and fuel lines. Always maintain this sequence.
Caution: When the red control lamp (Position 5 in the overview) lights up, the charging cables have been connec-
ted incorrectly. Remove the pole callipers from the battery poles and connect them correctly.

6.5 CHARGING THE BATTERY

Now connect the mains connection cable (Position 8 in the overview) of the battery charger to the power socket. Now the green
control lamp „ON" (Position 4 in the overview) and the yellow control lamp „CHARGING" (Position 3 in the overview) light up.
The battery is being charged.
Once the battery is fully charged, the battery charger switches over to maintenance mode. The green „FULL" control lamp (Posi-
tion 2 in the overview) lights up.
10
1 Carry handle
6 Mounts for cable holder
7 Type plate
8 Mains connection cable
9 Charging cable
Figure 2: View of rear