Operating Instructions; Overview; Charging The Power Pack; Charging The Power Pack: With The Plug - APA 16553 Manuel De L'opérateur

6. OPERATING INSTRUCTIONS

6.1 OVERVIEW

1 Handle
2 Control panel front
3 LED indicator fi eld
4 Jump lead (+)
5 Jump lead (-)
6 12 V outlete
7 Charge status display
8 Switch
9 Charging socket
10 USB control light
Figure 1: Overview
11 USB port
12 Compressor switch
13 Manometer
14 Rear side of control panel
15 Pole calliper (-)
16 Air hose storage
compartment
17 Pole calliper (+)
18 Plug charger
19 Motor vehicle charging cable

6.2 CHARGING THE POWER PACK

Fully charge up the Power Pack after purchase with the plug
charger before initial use (Section 6.2.1)

6.2.1 CHARGING THE POWER PACK: WITH THE PLUG

CHARGER

Make sure that the Power Pack is switched off . All control lights
and the work light must not be illuminated. Switch off the
compressor. Plug the coaxial connector of the plug charger
(Position 18 in the overview) into the charging socket of
the Power Pack (Position 9 in the overview). Now, connect
the plug charger with the mains socket. The charge status
display (Position 7 in the overview) is activated, and fl ashes.
If all three lights on the charge status display are always lit,
then the Power Pack battery is fully charged. After charging,
fi rst disconnect the plug charger from the mains socket, then
disconnect the coaxial connector from the charging socket of
the Power Pack.

6.2.2 CHARGING THE POWER PACK WITH THE MOTOR

VEHICLE CHARGING CABLE

Make sure that the Power Pack is switched off . All control
lights and the work light must not be illuminated. Switch
off the compressor. Plug the coaxial connector of the motor
vehicle charging cable (Position 19 in the overview) into the
charging socket of the Power Pack (Position 9 in the over-
view). Now plug the motor vehicle charging cable into the
12 V on-board socket in your car. The charge status display
(Position 7 in the overview) is activated, and fl ashes. If all
three lights on the charge status display are always lit, then
the Power Pack battery is fully charged. After charging,
fi rst disconnect the motor vehicle charging cable from the
on-board socket, then disconnect the coaxial connector from
the charging socket of the Power Pack.
CAUTION
Only charge the Power Pack when driving
or when the motor is running, otherwise
there is a risk that the starter battery of
your vehicle may be discharged.

6.3 STARTING AID

For instructions on carrying out a jump
start, read the manual of your vehicle or
ask your specialist workshop.
Disconnect all of the devices connected to the Power Pack
from the 12 V outlet socket (Position 6 in the overview) and
from the USB port (Position 11 in the overview).
Make sure that the Power Pack is fully charged. To do this,
press the ON/OFF switch (Position 8 in the overview). If all
three lights are illuminated on the charge status display
(Position 7 in the overview) then the Power Pack is ready to
use.
9