Routine Maintenance; Repairs - TECHNO-GAZ SLIM Notice D'utilisation Et D'entretien

TECNO-GAZ
No. Period
1 Before using
2 Before using
3 Every 6 months
4 Every 6 months
5 Once a year
Operation and
maintenance manual

7.4 Routine maintenance

CAUTION – Interrupt the power supply before doing any maintenance
CAUTION – Check Product integrity
Make sure there are no pieces or fragments of paint that could
become detached and fall within the operating field. If there are
any, remove them manually.
Make sure the light source protection screens are not damaged.
If they are, contact the Service Personnel and have them
replaced.
Check all the Product joints and make sure there are no noises
or squeaks. If there are, lubricate the clutches involved with
suitable grease for industrial use at a service temperature
between -30°C and + 120°C, type OKS 470 or similar
characteristics.
If the Product fails to maintain a regular position, adjust the
clutches as indicated at points 7.1 and 7.2 (arm and clutch
adjustment).
Make sure the bar retention screws are tightened properly. Also
check the bar horizontal arm retention screws and the swinging
arm screws.
If these are not properly fastened, adequately tighten.

7.5 Repairs

The Product must only be opened and repaired by the Service
Personnel.
jobs
CAUTION – Unsuitable repairs
MIU_023 04/02/16
Rev.1 Pag. 18 di 33
Job
EN