Adjustments And Maintenance; Setting The Swinging Arm; Clutch Adjustment; Periodical Checks To Be Performed On The Product - TECHNO-GAZ SLIM Notice D'utilisation Et D'entretien

TECNO-GAZ
See drawing 65
See drawing 65
Operation and
maintenance manual
burdened by other material being sterilized.
Damaged hand-pieces must no longer be used.

7 Adjustments and maintenance

7.1 Setting the swinging arm

The Product is sold already balanced and does not require further
adjustment. In the event of the spring swinging arm becoming stiff or
loose over time, mechanical intervention is possible by regulating the
compression of the internal spring.
Allow the silicone seal gasket (1) and the cover (2) to slide forwards
along the swinging arm (3). Fit a pin (4) with diameter of 4mm in the
holes of the ring nut (5) and turn in the direction indicated by the arrows
to increase/decrease the load on the spring.
If the swinging arm drops, this means the elastic force of the spring is
insufficient:
- turn the lever downwards and load the spring.
If the swinging arm lifts up, this means the elastic force of the spring is
too high:
- turn the lever upwards and release the spring.
After making adjustments, return the covering to its original position.

7.2 Clutch adjustment

Like all the other mechanical parts, the clutches are also subject to
wear.
In case of the structure not maintaining the position, the clutches
will have to be adjusted.
Use a 2.5 hexagon spanner (7) to increase the braking force, turning
the dowels (6) of the arm brake clockwise.
7.3 Periodical checks to be performed on the
Product
CAUTION – Product electrical check
At the time of start up and after each maintenance job, perform
electrical tests and jobs indicated in the IEC 62353 standard.
MIU_023 04/02/16
Rev.1 Pag. 17 di 33
EN