Fingerprint Reader (Option) - Clevo N85XEJEK1 Guide Utilisateur

Fingerprint Reader
(Optional for Models A & C Only)
Install the driver and enroll your fingerprints as instructed
below before use. The fingerprint reader module uses the
Sign-in options configuration of the Windows Account.
Fingerprint Sign-In Issues
If at the Windows Hello screen, the Fingerprint reader
fails to recognize the fingerprint 3 times it will then block
access to the computer. In this case you will need to use
your PIN (the PIN you used when initially setting up the
fingerprint reader) to access the computer. Alternatively
you can sign-in using your Windows password. After us-
ing the PIN code (or Windows Password) to access the
computer you can go to the Settings > Accounts >
Sign-in options if you wish to change any settings.
(Option)

Fingerprint Module Configuration
1. Click the Settings item in the Start Menu.
2. Click Accounts and then click Sign-in options.
3. You will need to add a Windows password (click Add under
Password).
4. After you have added the password you will need to also add a
PIN.
5. Under Windows Hello click Set up under Fingerprint.
6. The wizard will then guide you through the set up process to
scan your fingerprints.
7. You will be instructed to swipe the same finger across the
reader a number of times.
8. Click Close when complete.
9. You can choose to Add another finger (this is recommended) or
Remove the current fingerprint reading.
10. You can now scan your fingerprint to log-on to the computer.
Figure 26 - Accounts - Sign-in options
33