Haier WS50GA Mode D'emploi page 11

Wine Cellar Features And Use
• Once the temperature is set for the upper compartment, you will
notice the temperature display blink for the lower compartment.
Again press the up or down arrow button to increase or decrease
the temperature. Once the desired temperature is attained, press
the " " button. Doing this, the electronic control panel will
memorize the setting. The temperature display will revert back to
display the inside temperature. It may take some time to reach the
set temperature.
WS25GA/WS59GAE
• The wine cellar is preset from the factory to automatically
accommodate temperature requirements for red or white wines.
If you store mostly white wines, press the "
and the wine cellar will maintain an average temperature between
7° to 10 °C. Pushing the "
temperature between 13 °C to 16 °C.
• The wine cellar can be set to any temperature you desire to
accommodate your wine storage requirements. To set the
temperature, press both the "
simultaneously and hold for approximately 3 seconds. Now you are
in temperature set mode. Decrease the temperature by pushing
the "
the "
adjust the temperature 3 degrees, press 4 times equals 4 degrees,
5 times equals 5 degrees, and so on. Once you have selected the
temperature you desire, push the "
cellar is programmed and the LED readout will return to current
internal temperature reading.
Note:
for the improvement of humidity inside your wine cellar.
See
" button and increase the temperature by pressing
" button. Pressing the appropriate button 3 times will
" button will yield an average
" and "
" button. Now the wine
English
" button
" buttons
5