man_ECO1700('20) V7.indd 113
man_ECO1700('20) V7.indd 113
Unplug the stove at the mains socket before carrying out any
maintenance.
Task
Clean the exterior of the stove
Clean the window
Clean the brazier
Clean the ash drawer
Clean the heat exchanger
Clean the hearth
Check the seal on the fire door
Clean the pellet hopper and auger Once a month and/or when 2,500 kg of pel-
Clean the pellet supply pipe
6.2 CLEANING THE EXTERIOR OF THE STOVE
Clean the surface of the stove with hot water and soap. Do not use any abrasive or
solvent-based detergents as these could damage the stove's finish.
6.3 CLEANING THE WINDOW
The window in the stove door should be cleaned before every start-up to
prevent soot and ash particles from burning into the glass.
The glass is heat resistant but can crack due to rapid temperature changes. There-
fore allow the window to cool down completely before cleaning it. Use ordinary
glass-cleaning spray and cleaning cloths.
Only clean the glass window when the stove has completely cooled off!
6.4 CLEANING THE BRAZIER AND ASH DRAWER
The brazier and ash drawer must be cleaned before each start-up.
1.
Remove the brazier and the ash drawer from the combustion chamber. See
figure 7.
2.
Clean the ash drawer.
3.
Clean the brazier and its grate with a brush or vacuum cleaner. If the slots in
the grate are blocked, use a pointed instrument to clear them (see figure 8).
Frequency*
Every two weeks
Before every start-up. Also before start-up
when in timer mode
Before every start-up. Also before start-up
when in timer mode
When the drawer is full and before every
start-up. Also before start-up when in timer
mode
Daily
Every 2 weeks
Twice a year; first at the start of the season
and/or when 2,500 kg of pellets have been
burnt
lets have been burnt
Once a week
4
113
30-07-20 16:47
30-07-20 16:47