Operating; Filling With Water; Function Setting; Miscellaneous - Medisana FS 885 Mode D'emploi

3.1 Filling with water

Before filling the device with water, make sure that no mains leads are connected, i.e. the electricity
lead must not be plugged-in! When the foot spa comfort is securely placed on the floor (ensuring that
it cannot tip over), and has been filled with water, insert the mains plug into the power supply socket.
The MEDISANA FS 885 foot spa can be filled with up to 6 litres of water. The maximum filling height
is marked in the foot spray bath. You can use cold or warm water with or without bath additives,
just as desired.
CAUTION
Make sure that you use your MEDISANA foot spa comfort on a safe and
even surface that is not sensitive to moisture.
Never use any foaming bath additives or bath salts.

3.2 Function setting

ON/OFF
After connected with the mains, press the button
the starting temperature. When you press the switch
Temperature
The MEDISANA FS 885 foot spa comfort includes an innovative heating function. This technical
improvement makes it possible to keep the water at a constant temperature during application or to warm
it. When you switch on the device, the starting temperature appears in the display
press button , the set temperature increases by 3 °C up to 39 °C. From 39 to 48 °C, the temperature
increases by 1 °C each time you press button
shown in display .
Timer
Generally speaking you can take about 20 minutes for a footbath with a massage, once or twice daily.
When you switch on the device with button
to prolong the operation time in 10 minute steps up to 60 minutes. You should ensure that the
device has completely cooled off before it is used again!
air jet / vibration / red light
The device also has air jet/vibration/ red light functions. Press button
Pressing the button
WARNING
If you are very sensitive to heat, have cardiovascular problems, swellings,
inflammations, skin irritation or skin wounds, please consult your doctor
before use.

4 Miscellaneous

4.1 Cleaning and maintenance

• Before cleaning the device, make sure that it is turned off and the mains plug is removed from the
socket. Pour the water out of the device from one of the corners at the back and clean the device
with a cloth when it has cooled off.
3 Operating / 4 Miscellaneous
. When the device is on, the current temperature is always
again, the bubble function will be closed.
to switch on the appliance. The display
again, the appliance will be shut down.
, operation time is set to 20 minutes. Press button
shows
. Each time you
to switch on the functions.
GB
11