Switching Off; Dmx Mode - Velleman VDPLP64SLB Mode D'emploi

Master Dimmer
To adjust the overall brightness of the light output, press % and then press + or – to set the desired
brightness.
Adding a Strobe Effect
To add a strobe effect, proceed as follows:
1. Press STROBE and then press + or – to set the desired strobe speed.
2. To switch off the strobe effect, press STROBE again.

Switching Off

To switch off all LEDs, press BLACKOUT. Press BLACKOUT again to switch on.
11.

DMX Mode

This mode allows you to control the device by any universal DMX controller.
 All DMX-controlled devices need a digital start address so that the correct device responds to the signals.
This digital start address is the channel number from which the device starts to "listen" to the DMX
controller. The same starting address can be used for a whole group of devices or an individual address can
be set for every device.
 When all devices have the same address, all the units will "listen" to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you
set individual addresses, each device will "listen" to a separate channel number. Changing the settings of
one channel will only affect the device in question.
 In case of the 4-channel mode, you will have to set the start address of the first unit to 1 (CH1–4), the
second to 5 (1 + 4) (CH5–8), the third to 9 (5 + 4) (CH9–12), and so on. The highest start address is 509.
 In case of the 8-channel mode, you will have to set the start address of the first unit to 1 (CH1–8), the
second to 9 (1 + 8) (CH9–16), the third to 17 (9 + 8) (CH17–24), and so on. The highest start address
is 505.
To set the device to work with a DMX controller:
1. Press MENU until <4-CH> (for the 4-channel mode) or <8-CH> (for the 8-channel mode) is displayed and
press ENTER.
2. Use UP and DOWN to set the DMX starting address (d--1 to d512) and press ENTER.
DMX Channel Values
4 channel mode:
Channel From
1 0
2 0
3 0
4 0
8 channel mode:
Channel From
1 0
2 0
3 0
4 0
0
5
16
0
6 16
0
V. 02 – 30/06/2014
VDPLP64SLB
To Description
255 Red 0–100 %
255 Green 0–100 %
255 Blue 0–100 %
255 Amber 0–100 %
To Description
255 Red 0–100 %
255 Green 0–100 %
255 Blue 0–100 %
255 Amber 0–100 %
15 No function
255 Selection of predefined fixed colours
15 No function (if channel 7 is ≤ 31)
255 Strobe slow to fast (if channel 7 is ≤ 31)
255 Program speed slow to fast (if channel 7 is 32–223)
8 ©Velleman nv