Timer Operation; Using The Timer - Panasonic CZ-RWSU2 Mode D'emploi

6. Timer Operation

• When setting the timer, make sure the current time on the remote control is accurate.
• The timer's clock can only be set when the display of the remote control is ON.
• After setting the timer, put the remote control in a place where its signal will reach the receiver of the
indoor unit. (When the time set for the timer is reached, a signal is sent from the remote control to
Start/Stop the unit.)

Using the Timer

1. Press either /
being displayed, if you press
be set.
The time last set on the timer is displayed.
"--:--" indicates time to change the batteries.
2. Press either /
desired time.
Every time you press
If you press and hold the button, the time changes quickly.
3. After setting the timer, if you press
changes to a steady display, indicating settings are complete.
After the timer setting is displayed for three seconds, the display reverts to
the current time.
or , and while the time is
of the
/ again, a scheduled time can
or and set the timer to the
of the
/
, the time changes in 10 minute increments.
, the time you set
EN-9
3 1, 2
EN