Parts Included - Kenwood KSC-SW11 Mode D'emploi

Parts included

No. Part Name
Remote control
1
(5 m / 16 ft)
10-pin connector cord
2
(5 m / 16 ft)
Speaker cord
3
(4.3 m/ 14 ft)
4 Fixture A
5 Fixture B
Connection
Caution:
Before wiring, be sure to remove the wire from the negative terminal of the battery. After completing all wiring, check the
correct wirings again. After checking, connect the wire from the negative terminal of the battery.
■ Terminals of Subwoofer
■ Connecting the remote control unit
Connect with the lock
part of remote control
jack facing down.
Notes:
• Be sure to connect the supplied remote control unit.
• If the cord is not connected properly, the illumination on the remote control unit do not light up.
• Do not insert the remote control connector upside down or forcibly. Otherwise, malfunction may result.
Outside Shape Quantity
1
1
1
2
1
Lock part
No. Part Name
Tapping screw
6
(ø 5 × 16 mm)
Machine screw
7
(M4 × 5 mm)
Machine screw
8
(M3 × 8 mm)
Hook-and-loop fastener
9
(Double-side adhesive/
for Remote control)
POWER/SPEAKER INPUT terminal
REMOTE terminal
1 Remote control
Outside Shape Quantity
4
4
2
1
Lights in blue.
When the power turns
ON, the illumination
lights.
3
English