Hansgrohe Tango C 042720 Série Instructions De Montage / Mode D'emploi / Garantie page 6

1
2
1
3
6
2
3
English
Installation
Remove the plaster shields from the valves.
Close the valve cartridges.
Tango C only: Install the deco rings on the
handles.
Position the handle over the valve stem with the
lever in the desired "off" position.
Hold the lever in place with one hand. Use your
other hand to rotate the "bell" to secure it to the
valve.
Check the alignment of the handles.
If it is unsatisfactory, reinstall it.