Functional Description; Intended Use; Product Features - Bosch PTS 10 Notice Originale

OBJ_BUCH-783-001.book Page 40 Thursday, July 3, 2008 12:02 PM
40 | English

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.

Intended Use

The power tool is intended as a stationary ma-
chine for making straight lengthways and cross-
ways cuts in wood. Horizontal mitre angles of
– 60° to +60° as well as vertical bevel angles of
90° to 45° are possible.
The machine is designed with sufficient capacity
for sawing hard and softwood as well as press
and particle board.
When operating as a table saw, the power tool
is not permitted for cutting aluminium or other
non-ferrous metals or alloys.

Product Features

The numbering of the components shown refers
to the representation of the power tool on the
graphic pages.
1 Sliding table
2 Table extension
3 Insert plates
4 Riving knife
5 Vacuum connection on the blade guard
6 Blade guard
7 Sticker for marking of the cutting line
8 Parallel guide
9 Table width enlargement
10 Parallel fence of the table width enlarge-
ment 9
11 Saw table
12 Handwheel for lowering and raising the saw
blade
13 Scale for clearance of the saw blade to the
parallel fence 8
14 EMERGENCY OFF button
15 Guide groove for parallel fence 8
16 Angle stop
17 Ring spanner
1 609 929 R65 | (7/3/08)
18 Auxiliary parallel fence (aluminium)
19 Fastening screw of saw-blade storage
20 Mounting holes
21 Guide groove for angle stop
22 Hold-down stick
23 Fastening knob for table extension 2
24 Locking lever of the sliding table
25 Fastening knob for parallel fence 10
26 Fastening knob for table width
enlargement 9
27 Storage for auxiliary parallel fence 18
28 Storage for parallel fence 8
29 Locking knob for adjustment of bevel angles
30 Safety flap of On/Off switch
31 Cable holder
32 Sawdust ejector
33 Storage for angle stop
34 Vacuum hose
35 Bottom plate
36 Fastening kit for "riving knife"
37 Insert-plate notches
38 Saw blade
39 Fixture for riving knife
40 Fastening kit for "blade guard"
41 Fastening kit for "table extension"
42 Rubber buffer
43 Guide rail of the angle stop
44 Locking knob on the angle guide
45 Fastening kit for "auxiliary parallel fence/
angle stop"
46 Clamping knob of the parallel guide
47 Profile rail
48 Fastening knobs for auxiliary parallel fence
(aluminium)
49 Auxiliary parallel fence (plastic)
50 Spindle lock lever
51 Clamping nut
52 Supporting/clamping flange
53 Tool spindle
54 Locking knob for bevel angle (horizontal)
55 Angle indicator on the angle guide
56 Angle indicator (vertical)
Bosch Power Tools