Delivery Scope; Initial Operation - Bosch PTS 10 Notice Originale

OBJ_BUCH-783-001.book Page 42 Thursday, July 3, 2008 12:02 PM
42 | English
Assembly
Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.

Delivery Scope

Please also observe the repre-
sentation of the delivery scope
at the beginning of the operat-
ing instructions.
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Table saw
(Preassembled: Table width enlargement 9,
saw blade 38, insert plate 3)
– Bottom plate 35
– 4 Phillips screws for mounting of the bottom
plate
– Table extension 2
– Fastening kit for "table extension" 41
(2 guide rods, 2 securing screws, 2 clips,
2 short fastening knobs)
– Parallel fences 8 and 10
– Auxiliary parallel fence (aluminium) 18
with profile rail 47
– Auxiliary parallel fence (plastic) 49
– Angle stop 16
– Fastening kit for "auxiliary parallel fence" 45
(4 short screws, 2 long fastening knobs 48, 2
square nuts and washers)
– Blade guard 6
– Fastening kit for "blade guard" 40
(screw, nut, washer)
– Riving knife 4
– Fastening kit for "riving knife" 36
(2 hexagon bolts)
– Vacuum hose 34
– Hold-down stick 22
– Ring spanner 17 (23 mm; 10 mm)
1 609 929 R65 | (7/3/08)
for machine versions with base unit:
– Base unit 69
(12 Profiles, 4 end caps)
– Fastening kit for base unit 68
(24 screws with nuts for assembly, 4 screws
with nuts for fastening of the machine, 4
washers)
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.

Initial Operation

– Carefully remove all parts included in the de-
livery from their packaging.
– Remove all packaging material from the ma-
chine and the accessories provided.
– Take special care to ensure that the packag-
ing material under the motor block is re-
moved.
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
– Angle gauge
– Box-end or open-end spanner (size 13 mm)
for assembly of the base unit
Assembly Sequence
For easier working, observe the assembly se-
quence of the supplied product features.
1. Assembly from Below
– Vacuum hose 34
– Bottom plate 35
2. Assembly from Above
– Riving knife 4
– Blade guard 6
– Table extension 2
– Parallel fence 8, auxiliary parallel fences (18
or 49) and angle stop 16
Bosch Power Tools