Publicité
Les langues disponibles
Les langues disponibles
Congratulations on your purchase of the new AMPLITUDE!
The AMPLITUDE is a high-quality FRP hotliner with a dynamic flight envelope. It can be flown within a broad speed
range. There are various ways of constructing the model, depending on your preferences. Therefore the solutions
stated in this manual should only be considered as recommendations. For the most part, the PNP (plug and play)
version is already pre-assembled.
The ARF version (almost ready to fly) requires modeling experience and basic technical knowledge in construction.
Thus there are different ways to achieve a model with good flight skills.
This is why most steps are explained in the manual but not necessarily shown in the pictures.
PLEASE READ THIS MANUAL CAREFULLY BEFORE YOU START ASSEMBLING THE MODEL.
F L I G H T I N S T R U C T I O N S
• Before the first flight, observe the instructions in the „Safety Instructions" section.
• When flying the model, you should choose a day with as little wind as possible
• A large, flat area without obstacles (trees, fences power lines etc.) is suitable for the first flights.
• Please carry out a functional test of the drive train / power set and remote control.
• After assembling the model on the airfield, check once again that all model components such as wing, tail units,
wing mounts, engine, linkages, etc. are firmly and properly fastened.
• For a hand start a helper should be present, who can throw the model with enough thrust into the air.
• The start usually takes place against the wind.
• Do not stall the model near the ground
• Do not initiate tight turns in the immediate vicinity of the ground.
• Check the reactions of the model to the rudder deflections. If necessary, adjust after landing to increase or
decrease the deflections accordingly.
• The minimum flight speed must be at an adequate safety altitude.
• Initiate the landing with sufficient speed
S A F E T Y I N S T R U C T I O N S F O R R E C H A R G E A B L E B AT T E R I E S
• Do not immerse the battery in water or other liquids.
• Do not heat, throw into fire or microwave.
• Do not short-circuit or charge with reversed polarity
• Do not expose, deform or throw the battery
• Do not solder directly on the battery
• Do not change or open the battery
• Only charge the battery with suitable chargers, never connect it directly to a power supply unit.
• Never charge or discharge the battery or charger on a flammable surface.
• Never leave the battery unattended during charging or discharging processes.
• Never charge or discharge the battery in direct sunlight or near heaters or fire.
• Do not use the battery in places subject to high static discharge.
All this can cause the battery to be damaged, explode or even catch fire!
• Keep the battery away from children
• Keep leaked electrolyte away from fire, as it is highly flammable and may ignite.
• The electrolyte liquid should not get into the eyes, if it does, rinse immediately with plenty of clear water and
then see a doctor.
• The electrolyte liquid can also escape from clothes and other objects with a lot of water or washed off.
12
• Observe the safety instructions of the battery manufacturer and the charger manufacturer.
Instructions and User Manual
P R E FA C E
T E C H N I C A L D ATA
Span
1800 mm
Length
1040 mm
Weight (dry)
725 g
Flying weight
1590 g
Wing Area
27,8 dm²
Airfoil
MH-30
C.G.
68-72mm behind the leading edge
B O X C O N T E N T / N E E D E D A C C E S S O R I E S
ARF
Motor
not included
ESC
not included
Battery
not included
Servo ELE
not included
Servo RUD
not included
Servo AILE
not included
Servo FLAP
not included
Servo LANDING FLAP
not included
Servo cable
not included
Landing gear
not included
MULITlock
not included
MPX plugs
Yes (not included)
Adhesives
UHU Por (not included)
Epoxy resin
Yes (not included)
Locking screw
Yes (not included)
Velcro strap
not included
Spinner
not included
Propeller
not included
TX
min. 5 channels (not included)
RX
min. 7 channels (not included)
Elevator
Yes
Rudder
No
Ailerons
Yes
Flaps
Yes
Landing flaps
No
Motor
Yes
PNP
Robbe X36-800 (included)
from RoControl 6-60 (not included)
4S 3200-4000mAh (not included)
1x Robbe FS-155 BB MG HV (included)
-
2x Robbe FS-155 BB MG HV (included)
2x Robbe FS-155 BB MG HV (included)
-
3x 50cm, 2x 20cm, 4x 25cm MPX-JR Plug (included)
No
No
-
-
-
-
Yes
Alu Turbo Spinner 38mm (included)
12x8" CAM Prop (included)
min. 5 channels (not included)
min. 7 channels (not included)
Publicité
