Brandt AD 916 X Guide D'utilisation page 27

2 / INSTALLING YOUR APPLIANCE
• •
Recycling
-Calculate the final height for fixing the duct
support U-bracket (part B Pic 1)
-Mark the two holes.
-Drill 8 mm diameter holes and secure the
duct support bracket, ensuring that it is fixed
in the same axis as the hood (part B Pic 1)
-Fix the flat bracket behind the lower duct
(part C Pic. 4).
-Fit the sleeve adapter on the deflector (Pic.
8).
-Connect the extendable sleeve to the deflec-
tor.
-Fit the two parts of the duct on to the hood
(Pic. 5).
-Fit the deflector (Pic. 8) into the upper duct
by the ventilation inlets (Pic. 6).
-Make the electrical connection to the hood
using the mains supply cable.
-Lift the upper duct up to the ceiling and fix it
to the bracket using the two screws.
Tip
For optimal use of your appliance, we recommend that you connect the hood to a 150 mm-
diameter flue (not delivered with the appliance). Minimise the number of angles and bends and the
lengths of the flue. In the event that the hood will be operated using outdoor evacuation, you should
ensure a sufficient inflow of fresh air to avoid a pressure deficiency in the room.
Warning
Do not use tools to remove the safety film of hood
27
EN
pic. 12
pic.13