Dolmar RM-63.7 Manuel D'utilisation page 116

EN 34
6.4.3 E
LECTRIC AND PROTECTION SYSTEM
➤
In the electric start models:
The electric system and the electronic card
are protected by a fuse. When it blows the
machine stops, so in this case:
1. remove the engine housing (1) using a
screwdriver;
2. replace the fuse (2) with another one
with the same capacity;
3. remount the engine housing (1).
The fuse capacity is indicated on the fuse.
IMPORTANT
always be replaced by one of the same
type and ampere rating, and never with
one of another rating.
If you cannot find out why the fuse has blown, consult a Licensed Service
Centre.
➤
In the manual start models:
The electric system and the card are not protected by any fuses. If the safety
system fails to work properly or there are engine problems due to the electric
system, contact a Licensed Service Centre.
6.4.4 R
EPLACING THE BELT
The belt replacement must be carried out at a Licensed Service Centre.
NOTE
wear! ALWAYS USE GENUINE REPLACEMENT BELTS!
A blown fuse must
Replace the belts as soon as they show obvious signs of
1
2
MAINTENANCE