Unpacking And Assembly - Dolmar RM-63.7 Manuel D'utilisation

EN 8
3.

UNPACKING AND ASSEMBLY

IMPORTANT
starting up the engine, fill with oil and fuel following the instructions given in
paragraph 5.3.3. and in the engine manual.
For storage and transport reasons, some components of the machine have to be
assembled after their removal from the packing. Final assembly is carried out by
following these simple instructions.
3.1 UNPACKING
When unpacking the machine, take care to gather all the individual parts, fittings
and documentation.
NOTE
down from the pallet, take it to the maximum height and be very careful.
The supply includes:
– the battery;
– bolts and screws, necessary for completing the assembly;
– a syringe for draining the engine oil.
➤
In addition (
– a battery charger;
– 2 starter keys;
– a spare 10 A fuse, to be kept in case of
necessity.
3.2 FITTING THE STEERING WHEEL
Put the machine on a flat surface and
straighten up the front wheels.
1. fit the bellows (1) onto the column (2);
2. fit the steering wheel and its column (2)
onto the protruding shaft (3) and fasten it
with the screws (4) and nuts (5) supplied,
using both holes on the shaft (3).
The machine is supplied without engine oil or fuel. Before
o avoid damaging the cutting deck when getting the machine
in the electric start models):
UNPACKING AND ASSEMBLY
4
3
1
5
2
5