Dolmar RM-63.7 Manuel D'utilisation page 113

MAINTENANCE
set to 60-65 Nm. If necessary, replace nuts and bolts only with GENUINE
SPARE PARTS.
6.3.2 C
UTTING DECK ALIGNMENT
The cutting deck should be properly set to obtain a good cut.
NOTE
always be 5 - 6 mm lower than the rear.
1. Put the machine onto a flat surface and
check the tyre pressure;
2. put 26 mm blocks (1) under the front edge
of the deck and 32 mm blocks (2) under
the rear edge, then put the lifting lever into
position «1»;
3. loosen the nuts (3-5), the locknuts (4-6) on
the right and left-hand side and the nuts (7
– 8), so that the deck is resting firmly on
the blocks;
4. tighten the nut (3) and the locknut (4);
5. turn the nut (7) until the front part of the
deck just begins to rise;
6. turn the nut (5) until the rear part of the
deck just begins to rise and tighten the
locknut (6);
7. check the front part and if necessary, turn
the nut (7);
8. tighten the nut (8) on the pin (9).
If you are unable to adjust the cutting deck properly, consult a Licensed Service
Centre.
6.3.3 A
DJUSTING THE ENGAGEMENT AND BRAKE OF THE BLADE
When you operate the lever to disengage the blade, this also brings the brake
into operation for stopping the blade within few seconds. If this is faulty, contact
a Licensed Service Centre.
To achieve good results from cutting, the front part should
2
7 9 8
EN 31
1
3
4
6
5