Dmx 512 Connection - Evolite Infinium 2200 RGB Mode D'emploi

o DMX 512 connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or properly. Please note the starting
address depends upon which controller is being used. Only use a DMX cable and 3-pin XLR-plugs and connectors in order to connect
the controller with the fixture or one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried out in compliance with IEC
standards.
 Set up
Press "UP" or "DOWN" to choose functions in the same menu.
Press"ENTER" button to enter next menu.
Press "RETURN" button to return previous menu.
When you turn on the laser for the first time, it will take some seconds to auto load the built-in show.
Infinium 2200 RGB User Manual Ver. 1.00 Page 16