Dmx Connection; Set Up - Evolite HYBRID 10R Mode D'emploi

Always secure your fixture with a safety cable!
o DMX 512 connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or properly. Please note the starting
address depends upon which controller is being used. Only use a DMX cable and 3-pin XLR-plugs and connectors in order to connect
the controller with the fixture or one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried out in compliance with IEC
standards.

SET UP

Main Menu
DMX
MODE
SET
Hybrid 10R Manual Ver. 1.00
Dmx Address
Dmx Channel Mode
Wait for DMX signal
Master / Slave Mode
Sound Mode
Sound Sens
Manual Focus
Pan reverse
Tilt reverse
Pan memory
Tilt memory
Reset Color wheel
Reset Gobo wheel
1-512
16Ch/24Ch
Yes/No
Master/Slave
On/Off
0-100
0-255
Yes/No
Yes/No
Yes/No
Yes/No
Yes/No
Yes/No
Page 18