REMIS REMItop vario II Mode D'emploi page 11

2. Lightning
· The inner frame can be equipped with two halogen spot lights per head
· To switch on the lighting, actuate the rocker switch fitted to the side of
3. Ventilation option
· Depending on the variant, the inner frame can be equipped with fans for ventilation of the
living space. The fans are installed in the head piece and draw the air through ventilation
slots and blow it outside through the forced ventilation on the outer frame. The fans can
also be placed in operation when the roof dome is closed.
· To switch on the ventilation, actuate the rocker switch fitted to the side of the head pieces.
The fans in each head piece can be switched separately. The switches have two speed set-
tings. It is therefore possible to operate the fans at full power or at half power.
· To clean the filter mat, the ventilation grille can be removed from the head piece.
· For this purpose, please undo the screws for the ventilation grille using a small screwdriver.
· Vacuum clean the mat using a vacuum cleaner or clean it with warm water.
· Do not re-fit until the mat has dried completely.
· The fans are low maintenance. It should be checked at regular intervals whether any foreign
bodies have been drawn in. For this purpose, remove the ventilation grille and look whether
the ventilation ducts for the fans are clean.
Size Number of fans
400x400 2
* theoretical specifications
piece, depending on the variant, maximum 4 spot lights of 10W each.
the head pieces.
There is a risk of burns, as the lights can become
CAUTION!!!
very hot in operation. On changing a halogen
bulb, it is imperative you wait until the bulb and
the fitting have cooled down.
· Now lever the entire spot light out of the receptacle using a small
screwdriver. During this process, ensure the head piece is not dama-
ged.
· Lever the silver ring off the body of the light.
· Remove the faulty halogen bulb and replace it with a new bulb.
Ensure the maximum power rating of 10W is
NOTICE!!!
not exceeded. When fitting the halogen bulb,
do not take hold of it with your bare fingers,
otherwise its service life will be reduced.
· Assemble in the reverse order of removal.
Output (W)
2 x 10 W
Pressure (Pa)*
424
Voltage (V)
10,2 - 13,8 V
Air flow rate (m³/h)*
73
Current (A)
1,66 A
Voltage (V) Current (A)
10,2 - 13,8 V 1,5 A
11/28
US/GB