Alecto PAS-210A Mode D'emploi page 33

5. Treble control
6. CLIP LED. Illuminates at maximum power output
7. Input for line signals with 3.5mm stereo jack or cinch stereo input with
volume control (attention: the audio signal is reproduced in mono)
8. Bass control
9. Line output XLR (symmetrical) for another amplifier
10. MP3 VOLUME: volume control for the MP3 player
Power: 100Watt RMS-200Watt music
Frequency Response: 40Hz-20Khz
Power: 100Watt RMS - 200Watt music
Sensitivity: 93dB@1W/1m
Frequency Response: 40Hz-20KHz
IN
16
18
PAS-210P
PAS-210P
Sensitivity: 93dB@1W/1M
Impedance: 8Ω
Speakon Connection
Impedance: 8
1+=Positive
1-=Negative
2+ and 2-=No connection
18
OUT
17
33
11. Heat sink of the
amplifier; keep it free,
may become hot
12. Output with Speakon
plug for the PAS-210P
13. Power switch for on
or off
14. 230V mains voltage
input
15. Fuse holder with glass
fuse F2.5A
PAS-210P
16. IN: input of this
speaker box, here
you can connect the
cable coming from the
AS-210A
17. OUT: output for a link
to another speaker
box
PAS-210A&P
18. At the top and bottom
of both the PAS-
210A and the
PAS-210P a M8
screw connection
is located for
suspending hooks
with M8 screw thread
(not incl.)