Charging The Battery; Inserting The Label Cassette - Dymo LabelManager 280 Guide De Démarrage Rapide

Charging the Battery

A charging adapter is included with your label maker
for recharging the battery pack. Charging the battery
pack will take approximately three hours; however,
after charging for about 10 minutes, the label maker
can be used to print labels.
The charging adapter is only used for recharging
the battery pack; the charging adapter cannot be
used to power the label maker.
To recharge the battery
Plug the charging adapter into the
1
power connector on the top of the
label maker. See Figure 2.
Plug the other end of the charging
2
adapter into a power outlet.
Make sure to read the Li-ion Safety
Precautions found on page 8.

Inserting the Label Cassette

Your label maker uses DYMO D1 label
cassettes.
To insert the label cassette
Lift the back cover of the label maker to open the label compartment.
1
Make sure the tape and ribbon are taut across the
2
mouth of the cassette and that the tape passes
between the label guides. See Figure 3.
If necessary, turn the ribbon rewind spool
clockwise to tighten the ribbon.
Insert the cassette with the label facing out and
3
positioned between the label guides. See Figure 3.
Press firmly until cassette clicks into place. See
4
Figure 4.
Close the back cover.
5
Ribbon rewind spool
Label
guides
Figure 3
Figure 2
Click!
Figure 4
3