HumanTechnik LA-60 Mode D'emploi page 10

- If using only one microphone ensure that you adjust this control to
give the maximum output signal.
- Turn the balance control clockwise for channel 1 (mic 1), and anti-
clockwise for channel 2 (mic 2).
- If using both microphones use the balance control to get optimum
performance from both microphones.
- Each microphone channel can alternatively be used as a line input for
connection to other audio equipment. (If using this method turn the
balance control away from the input being used).
Operation
• When using a microphone, either microphone socket can be used, adjust
the balance control to gain the maximum output signal.
• To connect a loop pad push the exposed metal of the lead into the loop
connectors ensuring that only the metal is gripped in the terminal.
To release the cable press the grey buttons down with a screwdriver and
pull the cable free.
• Before switching the unit on ensure that the volume control is set to its
minimum level and the balance control is set to the middle poistion.
• Switch on the amplifier by pressing the POWER button on the mains
socket, the green power light will then be illuminated.
• Ensure that the hearing aid wearer switches their aid to the the "T" or
"MT" position.
• Adjust the volume control for best results.
• Adjust the balance control to optimise the signal from the microphone or
sound source.
Attention:
Before connection/disconnecting cables remove the LA-60 from the
main socket.
10 English