Power Failure; Cleaning - Gram Gastro 07 Mode D'emploi

Power failure

In the event of a power failure, the control remembers the temperature setting and restarts the
cabinet when power is restored. If the power failure persists for some time, the control might
revert to the factory setting.

Cleaning

Always disconnect the counter before cleaning.
Do not flush compressor compartment and evaporator with water as this may cause short-
circuits in the electrical system.
The counter should be cleaned internally with a mild soap solution at suitable intervals and
checked thoroughly before it is put into operation again.
For the external maintenance – use stainless steel polish.
Cleansing agents containing chlorine or compounds of chlorine as well as other
corrosive means, may not be used, as they might cause corrosion to the stainless panels of
the cabinet and the evaporator system.
The compressor compartment and in particular the condenser must be kept free from dust and
dirt. This is best done with a vacuum cleaner and a brush.
The air filters on the condenser and the front panel can be removed and cleaned in a
dishwasher at max. 50°C.
Cleaning of counters with drawers:
If the counter is equipped with drawers and the bottom, sides or back wall require cleaning, the
drawers can be removed as follows:
Pull out the drawer. Lift it up, after which the drawer can be pulled of the extension rails
(Illustration 1A, 1B, 1C)
After cleaning, the drawer can be replaced. Place the drawer on the outer wheels on the
telescopic rails. Lower the drawer into a horizontal position after which it can be pushed into a
closed position. The drawer is now securely positioned.
765041236
20