Electrical Connection - Gram Gastro 07 Mode D'emploi

All products to be stored, that are not wrapped or packed, must be covered in order to avoid
unnecessary corrosion of the inner parts of the counter.
In places where warning triangles and/or screws are used to secure covers around electrical
parts, heating elements, compressor, fans, etc., there is a risk of severe injury if covers are
removed. Therefore, covers must only be removed by a service technician.

Electrical connection

The counter is intended for connection to alternating current. The connection values for voltage
(V) and frequency (Hz) are given on the nameplate.
Power must be connected via a wall socket. The wall socket should be easily accessible.
All earthing requirements stipulated by the local electricity authorities must be observed. The
counter plug and wall socket should then give correct earthing. If in doubt, contact your local
supplier or authorized electrician.
Warning !
This counter must be earthed.
The flexible cord fitted to this appliance has three cores for use with a 3-pin 13-Amp or 3-pin
15-Amp plug. If a B.S. 1363 (13-Amp) fused plug is used, it should be fitted with a 13-Amp
fuse.
Important
The wires in this mains lead are coloured in accordance with the following code:
GREEN-AND-YELLOW: EARTH BLUE: NEUTRAL
BROWN: LIVE
The colours of the wires in the mains lead of this appliance might not correspond with the
colour marking identifying the terminals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW wire to the plug terminal marked by "E" or an earth
symbol, or coloured GREEN-AND-YELLOW.
Connect the BLUE wire to the plug terminal marked "N" or coloured BLACK. Connect the
BROWN wire to the plug terminal marked "L" or coloured RED.
765041236
15