Temperature Setting; Error Codes On The Display - Gram Gastro 07 Mode D'emploi

Temperature setting

Temperature control:
P
Temperature regulation:
Temperature up:
Temperature down:

Error codes on the display

F1 If code F1 is displayed it means that the cabinet temperature sensor is defective and
service assistance should be requested. In the meantime the counter itself will
maintain the set temperature by the memory of the controller.
F2 If the display alternates between temperature and error code F2 there are problems
with the temperature sensor on the evaporator. This has no effect on the operation
of the couter, but the sensor should be replaced as soon as possible. Request
service assistance.
F3 If the display alternates between temperature and error code F3 there are problems
with the temperature sensor on the condenser. This has no effect on the operation of
the counter, but the sensor should be replaced as soon as possible. Request service
assistance.
NOTE! Applies only to cabinets with built-in compressor.
. .
If the dots in the display flash, it indicates that the condenser temperature is too high.
Switch off the counter at the mains and see whether the condenser has been
covered. If this is not the case, the high temperature might be the result of dirt on the
condenser. The condenser can be cleaned with a brush or vacuum cleaner. Switch
on the counter again. After an hour, the counter should run normally. If the dots
begins flashing again, request service assistance.
NOTE! Applies only to cabinets with built-in compressor.
765041236
Press to see the temperature setting; the display will show the set
temperature.
P
Keep pressed. At the same time, press
+
Each time is pressed the temperature will change one degree. When
the display shows the desired temperature let go of the two keys and the
setting has been made.
P
Keep pressed. At the same time, press
-
Each time is pressed the temperature will change one degree.
When the display shows the desired temperature let go of the two keys
and the setting has been made.
+
.
-
.
17