Preparing The Walkie−Talkies For Use - switel WTC 516 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3 Preparing the Walkie−Talkies for Use
Safety information
Caution: It is essential to read the Safety Information in
Chapter 1 before starting up.
Checking the contents of the package
The package contains:
− two walkie−talkies
− a charging station
− two belt clips
Connecting the charging station
Connect the charging station as illustrated in
the diagram. For safety reasons, only use
the power adapter plug supplied.
Inserting the battery pack
Open the battery compartment cover. Insert the battery pack
supplied. Pay attention to correct polarity. Close the battery
compartment cover.
Caution: Standard rechargeable batteries and
power packs cannot be charged in the charging
station. Only use the battery pack supplied or ones
of the same type.
Charging the battery pack
Before using the walkie−talkies for the first time, place them in the charging sta-
tion for at least 14 hours. When the walkie−talkies are inserted correctly in the
charging station, the red LEDs light up. They also light up when the battery packs
are fully charged.
Do not charge the walkie−talkies with charging units from other manufac-
turers.
The battery capacity is indicated in the display by the
Full
The battery pack needs to be recharged immediately two acoustic warning sig-
nals are issued and the display goes out.
Attaching the belt clips
Slide the belt clip in the guide from the top until it audibly
snaps into place. To detach the belt clip, prize the fastening
tab up a little with your fingernail and slide the belt clip upwards.
Preparing the Walkie−Talkies for Use
− two rechargeable battery packs
− a power adapter plug
− an operating manual
Half empty
Low
Mains power outlet
icon.
Empty
35

Publicité

Table des Matières
loading

Table des Matières