Varma Tec V400F2 Mode D'emploi page 11

INSTRUCTIONS FOR REPLACING THE BULB
WARNING - The VARMA FIRE guarantee does not cover replacement or repair of the bulb.
To change the bulb contact a professionally qualified electrician or assistance service.
To change the bulb, follow the instructions given below in the order indicated.
1. Disconnect the heater from power supply
2. Loosen the screws that fix the rim
3. Remove the two end sides and the cover from the body
4. Remove the bulb from the supports/spring
5. Slide the two silicon washers backwards along the wire for two/three centimetres
6. Extract the two female fastons connected to the male fastons of the bulb or loosen the small screws of the clamp that connect the
bulb pins and the wire.
7. Insert the new bulb in the female fastons and fit the silicone washers back onto the two end sides or insert the pin of the new
bulb and the wire in the clamp; tighten the two small screws. Refit the silicone washers so that they cover the connections.
8. Replace the cover and the two end sides as they were originally assembled.
9. Replace the rim and tighten it.
If necessary contact our technical office.
11