Important Safety Instructions For Battery Charger - Hitachi CR 18DL Mode D'emploi

IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CHARGER

WARNING:
READ ALL INSTRUCTIONS
1. This manual contains important safety and operating instructions for battery charger
Model UC18YRL, UC18YFL and UC18YGL2.
2. Before using battery charger, read all instructions and cautionary markings on (1) battery
charger, (2) battery, and (3) product using battery.
3. To reduce risk of injury, charge HITACHI rechargeable battery type EB7, EB9, EB12,
EB14, EB18, BCL14, BCL18 and EBM18 series. Other type of batteries may burst causing
personal injury and damage.
4. Do not expose battery charger to rain or snow.
5. Use of an attachment not recommended or sold by the battery charger manufacturer
may result in a risk of fire, electric shock, or injury to persons.
6. To reduce risk of damage to electric plug and cord, pull by plug when disconnecting
battery charger.
7. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
8. An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire and electric shock.
If extension cord must be used make sure:
a. That blades of extension cord are the same number, size, and shape as those of
plug on battery charger:
b. That extension cord is properly wired and in good electrical condition; and
c. That wire size is large enough for AC ampere rating of battery charger as specified
in Table 1.
AC Input Rating Amperes*
Equal to or
greater than
0
2
3
* If the input rating of a battery charger is given in watts rather than in amperes, the
corresponding ampere rating is to be determined by dividing the wattage rating by the
voltage rating–for example:
Death or serious bodily injury could result from improper or unsafe
use of battery chargers. To avoid these risks, follow these basic safety
instructions:
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
but less
than
2
3
4
1,250 watts
= 10 amperes
125 volts
Table 1
AWG Size of Cord
Length of Cord, Feet (Meter)
25 (7.5) 50 (15)
18 18
18 18
18 18
English
100 (30) 150 (45)
18 16
16 14
16 14
9